[wplug] how much RAM does my VGA have?
Alexandros Papadopoulos
apapadop at cmu.edu
Fri Mar 28 03:11:09 EST 2003
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hi list!
I was wondering how it's possible to establish the amount of RAM of the
graphics card. I can see the following (with lspci -vv), but can't
discern the information I seek:
01:00.0 VGA compatible controller: S3 Inc. SuperSavage IX/C SDR (rev 05)
(prog-if 00 [VGA])
Subsystem: IBM ThinkPad T23 (2647-4MG)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (1000ns min, 63750ns max), cache line size 08
Interrupt: pin A routed to IRQ 11
Region 0: Memory at c0100000 (32-bit, non-prefetchable)
[size=512K]
Region 1: Memory at e8000000 (32-bit, prefetchable) [size=64M]
Region 2: Memory at e4000000 (32-bit, prefetchable) [size=64M]
Region 3: Memory at e0000000 (32-bit, prefetchable) [size=32M]
Expansion ROM at <unassigned> [disabled] [size=64K]
Capabilities: [dc] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [80] AGP version 2.0
Status: RQ=31 SBA- 64bit- FW- Rate=x1,x2,x4
Command: RQ=0 SBA- AGP- 64bit- FW- Rate=<none>
I'm under the impression it has 8MB, but I'd like hard facts :-)
Cheers
- -A
- --
http://andrew.cmu.edu/~apapadop/pub_key.asc
3DAD 8435 DB52 F17B 640F D78C 8260 0CC1 0B75 8265
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (GNU/Linux)
iD8DBQE+hAOjgmAMwQt1gmURAmETAJ4o9xkMFQMTUJkYijUTsZ5YrHiZkgCfYnlA
gnieVjzRYF6gwtCsyClk2ho=
=Yfo4
-----END PGP SIGNATURE-----
More information about the wplug
mailing list