[wplug] Duplicate ETH0, different hardware address

[scoob8000]

I've used ifconfig eth0:0 to add a second IP address to the interface
before, but is
it possible to give the copy of the interface a different hardware address?

The following results in both eth's having the same hardware address.  Is
there anyway around this?
ifconfig eth0:0 hw ether aa:bb:cc:dd:ee:ff


-Mike
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.wplug.org/pipermail/wplug/attachments/20070226/ce9550bd/attachment.html