[wplug] digital camera and Gentoo

[Tom McCullough]

Hi everybody.  It's been a while since I had my linux partition working, 
(and thus since I could post properly:))  but I've got most of the bugs 
worked out of the bootable raid-0 array (Silicon Image 3112 on ASUS 
A7N8X deluxe with two Maxtor 80Gb SATA drives) I installed in December.  
I finally settled on Gentoo because Thomas Horsten has the only medley.o 
precompiled driver I am aware of and it worked with the Gentoo LiveCD 
distro.  I have since recompiled (ad nauseum) a decent 2.4.22 kernel and 
I've got a fair handle on the peculiarities of Gentoo, but I am having a 
rough time getting my digital camera to mount.

Here is a snip from dmesg:

hub.c: new USB device 00:02.0-3, assigned address 3
usb.c: USB device 3 (vend/prod 0x686/0x401a) is not claimed by any 
active driver.
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
usb-storage: act_altsettting is 0
usb-storage: id_index calculated to be: 73
usb-storage: Array length appears to be: 75
usb-storage: USB Mass Storage device detected
usb-storage: Endpoints: In: 0xe2439ad4 Out: 0xe2439ac0 Int: 0x00000000 
(Period 0)
usb-storage: New GUID 0686401a0000000000000000
usb-storage: GetMaxLUN command result is -110, data is 128
usb-storage: Transport: Bulk
usb-storage: Protocol: Transparent SCSI
usb-storage: *** thread sleeping.
scsi1 : SCSI emulation for USB Mass Storage devices
usb-storage: queuecommand() called
usb-storage: *** thread awakened.
usb-storage: Command INQUIRY (6 bytes)
usb-storage: 12 00 00 00 ff 00 80 f6 ac 28 8a f6
usb-storage: Bulk command S 0x43425355 T 0x1 Trg 0 LUN 0 L 255 F 128 CL 6
usb-storage: Bulk command transfer result=0
usb-storage: usb_stor_transfer_partial(): xfer 255 bytes
usb-storage: usb_stor_bulk_msg() returned 0 xferred 36/255
usb-storage: Bulk data transfer result 0x1
usb-storage: Attempting to get CSW...
usb-storage: Bulk status result = 0
usb-storage: Bulk status Sig 0x53425355 T 0x1 R 219 Stat 0x0
usb-storage: Fixing INQUIRY data to show SCSI rev 2 - was 0
usb-storage: scsi cmd done, result=0x0
usb-storage: *** thread sleeping.
  Vendor: MINOLTA   Model: DIMAGE CAMERA     Rev: 1.00
  Type:   Direct-Access                      ANSI SCSI revision: 02

Where should I put the block device? Or should one have been created 
already and if so where?
I have two DVD drives and they are ide-scsi.  They are at 
/dev/scsi/host0/bus0/target0/lun0/cd and ..../target1/lun0/cd.  I have 
both host0 and host1 each with one bus entry.  Any help would be 
appreciated.