[wplug] Wireless VPN
Teodorski, Chris
cteodorski at MahoningCounty.org
Tue Jan 27 15:07:44 EST 2004
Same here. Please let us know.
-----Original Message-----
From: Robert E. Coutch [mailto:robert.coutch at verizon.net]
Sent: Tuesday, January 27, 2004 2:46 PM
To: wplug at wplug.org
Subject: Re: [wplug] Wireless VPN
Where'd you get a Linux client for Cisco and is it a recent version.
The only one I could find was an old tarball for RedHat 7.x .
We use the Cisco VPN client for Windows at work and I was hoping to get
my Linux box to be able to access VPN from home.
Thanks for any info,
Bob
On Tuesday 27 January 2004 01:11 pm, Embery, Nathan wrote:
> Are you sure your firewall is configured to allow VPN traffic?
> Also, make sure your group password is correct in the .pcf file for your
> connection. If you're not sure, just clear it out and the connection will
> prompt you for one.
>
> Nate
>
>
> -----Original Message-----
> From: Patrick Weber [mailto:paw160 at psu.edu]
> Sent: Tuesday, January 27, 2004 11:54 AM
> To: wplug at wplug.org
> Subject: [wplug] Wireless VPN
>
>
> I am running RH9.0 on a laptop. I have a NetGear MA401 wireless pcmcia
> card that I have been trying to get working with the wireless network at
my
> school (penn state). RH uses the orinoco_cs driver and configures the
> device as eth1. I am able to lease an IP using DHCP just fine. When I
run
> my VPN client (Cisco VPN Client) it says that it is initializing IPSec and
> then says that it is trying to communicate with the gateway. At this
point
> it fails and says that "the remote peer has stopped communicating". Has
> anyone dealt with a problem like this before?
>
> Thanks,
> -Pat Weber
> paw160 at psu.edu
_______________________________________________
wplug mailing list
wplug at wplug.org
http://www.wplug.org/mailman/listinfo/wplug
More information about the wplug
mailing list