[wplug] setting up Iomega on RedHat 8.0

[Jay]

I was using the wrong module.  It is a zip plus drive so I used imm.o
module  and everything worked fine.  I have one more problem I can't figure out how to get the module "imm.o" to load on bootup.  I have done this before in RedHat only I can not remember how to do it. I've read several module HowTo and they do not tell how to do it.  Thanks for the help. 

Jay

On Mon, May 19, 2003 at 11:45:12AM -0400, Procario, Michael wrote:
> You do not have the scsi modules loaded. The Zip drive even used over the
> parallel port uses scsi commands. Try
> 
> modprobe ppa
> 
> Modprobe will try to resolve dependencies in modules and load all of the
> ones you need. 
> 
> Mike
> 
> 
> 
> 
> > -----Original Message-----
> > From: Jay [mailto:wplug at caldron.com] 
> > Sent: Monday, May 19, 2003 11:16 AM
> > To: wplug at wplug.org
> > Subject: [wplug] setting up Iomega on RedHat 8.0
> > 
> > 
> > I am trying to set up an Iomega Zip drive on a system running 
> > RedHat 8.0.  When I issue the command: #  /sbin/insmod ppa I 
> > receive the following Using 
> > /lib/modules/2.4.18-14/kernel/drivers/scsi/ppa.o
> > /lib/modules/2.4.18-14/kernel/drivers/scsi/ppa.o: unresolved 
> > symbol scsi_register_R0ac6db10
> > /lib/modules/2.4.18-14/kernel/drivers/scsi/ppa.o: unresolved 
> > symbol scsi_unregister_module_R81d85a75
> > /lib/modules/2.4.18-14/kernel/drivers/scsi/ppa.o: unresolved 
> > symbol scsi_register_module_Rfa20b7b0
> > 
> > I have read the Zip Drive HowTo and scanned Google without 
> > finding anything help in English. 
> > 
> > Thanks in advance for suggestions
> > Jay
> > 
> > _______________________________________________
> > wplug mailing list
> > wplug at wplug.org
> > http://www.wplug.org/mailman/listinfo/wplug
> > 
> 
> _______________________________________________
> wplug mailing list
> wplug at wplug.org
> http://www.wplug.org/mailman/listinfo/wplug