[wplug] the scsi problems continue
William Powell
billpwl1 at attbi.com
Fri Nov 8 00:27:15 EST 2002
Bill wrote:
>(scsi0:A:1:0): parity error detected in Data-in phase. SEQADDR(0x16c)
>
>
Without digging out all of my SCSI hardware documentation, I might
suggest that you check the PARITY configuration of your controller and
the drive in question. There is a jumper on the back of the drive that
selects the PARITY level and and a jumper that selects whether PARITY is
used or not. If this was pulled from other equipment, it might be an issue.
Bill Powell
More information about the wplug
mailing list