[wplug] the scsi problems continue
Bill
bhalpin at collaborativefusion.com
Thu Nov 7 12:27:13 EST 2002
Hello
I'm still having problems trying to mount this stupid drive. I did
notice this in dmesg this time, never noticed this before.
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.6
<Adaptec 2940 Ultra2 SCSI adapter>
aic7890/91: Ultra2 Wide Channel A, SCSI Id=7, 32/253 SCBs
Vendor: SEAGATE Model: ST32550W SUN2.1G Rev: 0416
Type: Direct-Access ANSI SCSI revision: 02
scsi0:A:1:0: Tagged Queuing enabled. Depth 253
Attached scsi disk sda at scsi0, channel 0, id 1, lun 0
(scsi0:A:1): 20.000MB/s transfers (10.000MHz, offset 15, 16bit)
(scsi0:A:1:0): parity error detected in Data-in phase. SEQADDR(0x16c)
SCSIRATE(0x98)
(scsi0:A:1:0): Unexpected busfree in Data-in phase
SEQADDR == 0x1a6
sda : READ CAPACITY failed.
sda : status = 0, message = 00, host = 1, driver = 00
sda : sense not available.
sda : block size assumed to be 512 bytes, disk size 1GB.
sda:SCSI disk error : host 0 channel 0 id 1 lun 0 return code = 10000
I/O error: dev 08:00, sector 0
SCSI disk error : host 0 channel 0 id 1 lun 0 return code = 10000
I/O error: dev 08:00, sector 2
SCSI disk error : host 0 channel 0 id 1 lun 0 return code = 10000
I/O error: dev 08:00, sector 4
SCSI disk error : host 0 channel 0 id 1 lun 0 return code = 10000
I/O error: dev 08:00, sector 6
SCSI disk error : host 0 channel 0 id 1 lun 0 return code = 10000
I/O error: dev 08:00, sector 0
SCSI disk error : host 0 channel 0 id 1 lun 0 return code = 10000
I/O error: dev 08:00, sector 2
SCSI disk error : host 0 channel 0 id 1 lun 0 return code = 10000
I/O error: dev 08:00, sector 4
SCSI disk error : host 0 channel 0 id 1 lun 0 return code = 10000
I/O error: dev 08:00, sector 6
unable to read partition table
Does this mean anything to anybody else?
-b
More information about the wplug
mailing list