[wplug] lost partition table
Rafael E. Herrera
raffo at neuronet.pitt.edu
Sat Jul 20 14:28:32 EDT 2002
coldfire wrote:
> the quick story .. i bought a new motherboard and a new hard disk .. i
> swapped all of my periphs over to the new motherboard and started playing
> quake 3 when i realized, why not install the new hard disk too? so i
> plugged in the new hard disk and set it to be the primary master. i set
> my old drive to be the primary slave. i booted off of some linux 2.4.18
> boot disks i had, only to witness that my old drive no longer had a
> partition table!
>
> i've tried setting it back to the primary master, and even plugged it back
> into the old motherboard (suspecting geometry changes in the bios). still
> not bootable, still no partition table. i was just wondering if anyone
> has recovered from such a situation .. or knows how to :) let me know,
> thanks
Make sure your jumper settings for your old drive are set properly. New
drives are usually set from the factory as masters.
Try just connecting the old drive by itself.
--
Rafael
More information about the wplug
mailing list