[wplug] Ethernet Card

[Eric Hsiung]

Sorry, meant to say you need the "EZstart" config tool.
You can download it here:
http://drivers.on-line.net.nz/software/configuration
or here:
http://www.unibw-hamburg.de/RZWEB/netz/swha/net-card/smc

It's a DOS program so you'll need a DOS boot disk.


Eric

----- Original Message -----
From: "Eric Hsiung" <ehsiung at bellatlantic.net>
To: <wplug at wplug.org>
Sent: Thursday, November 29, 2001 7:14 PM
Subject: Re: [wplug] Ethernet Card


> Sounds like an SMC EtherEZ card. Try the smc-ultra driver.
> You'll need the "EtherEZ" configuration tool to turn off
> PNP and set the IRQ and IO address.
>
>
> Eric
>
> ----- Original Message -----
> From: "Romano, Christopher" <cjr6 at exchange.cis.pitt.edu>
> To: <wplug at wplug.org>
> Sent: Thursday, November 29, 2001 9:04 AM
> Subject: [wplug] Ethernet Card
>
>
> > I have 2 NICs in my machine and I can't get one working.  I believe that
> it
> > is a Kingston but not sure.  I looked at the numbers on it and it says
SMC
> > 83C795QF P which I believe is the chipset.  I can't find what mod that
it
> > uses.  I tried going to kingston's website but it's down.  I don't know
if
> > they are out of business or that their site is just down.  Also when I
do
> an
> > ifconfig I get lo and eth0 which is good.  When I do ifconfig -a it also
> > list dummy0.  Shouldn't it say eth1?
> >
> > Chris
> > _______________________________________________
> > wplug mailing list
> > wplug at wplug.org
> > http://www.wplug.org/mailman/listinfo/wplug
>
> _______________________________________________
> wplug mailing list
> wplug at wplug.org
> http://www.wplug.org/mailman/listinfo/wplug