[wplug] Ethernet Card
Eric Hsiung
ehsiung at bellatlantic.net
Thu Nov 29 19:14:40 EST 2001
Sounds like an SMC EtherEZ card. Try the smc-ultra driver.
You'll need the "EtherEZ" configuration tool to turn off
PNP and set the IRQ and IO address.
Eric
----- Original Message -----
From: "Romano, Christopher" <cjr6 at exchange.cis.pitt.edu>
To: <wplug at wplug.org>
Sent: Thursday, November 29, 2001 9:04 AM
Subject: [wplug] Ethernet Card
> I have 2 NICs in my machine and I can't get one working. I believe that
it
> is a Kingston but not sure. I looked at the numbers on it and it says SMC
> 83C795QF P which I believe is the chipset. I can't find what mod that it
> uses. I tried going to kingston's website but it's down. I don't know if
> they are out of business or that their site is just down. Also when I do
an
> ifconfig I get lo and eth0 which is good. When I do ifconfig -a it also
> list dummy0. Shouldn't it say eth1?
>
> Chris
> _______________________________________________
> wplug mailing list
> wplug at wplug.org
> http://www.wplug.org/mailman/listinfo/wplug
More information about the wplug
mailing list